Lets you check the status of the image signals being projected and the status of the projector. Items that can be displayed vary depending on the image signal or
input source being projected as shown in the following screen shots.
RGB Signal/Component Video
g
Signal Composite video
g
Signal/S-Video
g
Signal USB/LAN
Sub Menu Function
Lamp Hours You can display the cumulative lamp operating time
*1
.
When it reaches the lamp warning time, the characters are displayed in yellow.
Source You can display the Source name for the connected equipment currently being projected.
Input Signal You can display the content of Input Signal set in the Signal menu according to the Source.
Resolution You can display the Resolution.
Video Signal You can display the content of Video Signal set in the Signal menu.
Refresh Rate You can display the Refresh Rate
g
.
Sync Info You can display the image signal information.
This information may be needed if service is required.
Status This is information about errors that have occurred on the projector.
This information may be needed if service is required.
Serial Number Displays the projector's serial number.
Event ID When problems occur when the projector and computer are connected through the network, information on the problem is displayed using
an Event ID. Refer to the following page for information on interpreting the Event ID. s p.92
*1 The cumulative use time is displayed as "0H" for the first 10 hours. 10 hours and above is displayed as "10H", "11H", and so on.
Info Menu (Display Only)75