Connecting to a Computer
■ ■ ■ ■ ■
■
31
4. Connect the other plugs on the audio/video cable to the
Audio jacks of the projector: insert the white plug into the
L jack and the red plug into the R jack. Connect the plug
at the other end of the audio/video cable to the audio
output jacks of the video source.
5. For S-Video, insert one end of an S-Video cable into the
projector’s S-Video connector. Insert the other end into
the S-video-out jack of your video source.
6. For component, insert three ends of a BNC cable into the
projector’s R/R-Y, G/Y and B/B-Y jacks. Insert the
opposite ends of the cable into the Y/Video, C/R-Y, and
B-Y jacks on your component video source. (Don’t insert
any of the cable ends into the HD/Sync and VD jacks.)
7. Make sure the Computer 2/BNC switch is set to BNC.
♦
Note:
When the Computer 2/BNC switch is set to BNC, the
projector is unable to project the Computer 2 image signal.
♦
Note:
Use a standard BNC cable, which you can purchase from
any computer store. The 5BNC video cable supplied by EPSON
as an optional accessory does not work with component video.
S-Video connector S-Video cable