The lamp will switch off automatically
and projection will stop.
Wait for approximately 5 minutes.
Then disconnect the power cable and
check the points to the right.
User's Guide "Replacing the Lamp"
Warm-up time is approximately 40 seconds.
After warm-up is complete, the indicator will change to steady green and projection will start.
Normal operation is in progress.
Cool-down time is approximately 30 seconds.
After cool-down is complete, the projector goes into standby mode.
You cannot use the remote control or the projector's control panel during cool-down.
If you continue using the projector and
the temperature rises again, the lamp
will switch off automatically.
Check the points to the right.
If the problem is not fixed, stop
using the projector and
disconnect the power plug from
the electrical outlet.
Then contact your dealer or the
nearest address provided in the
"International Warranty
Conditions" section of the
Safety Instructions/World Wide
Warranty Terms
booklet.
If the projector
is close to a
wall, move it
away from the
wall.
Clean the air
filters if they are
blocked.
If the indicator is flashing orange Warning lit flashing off
High-speed
cooling in
progress
Warm-up in
progress
Cool-down in
progress
Internal
temperature
error
(overheating)
Standby
condition
Projection in
progress
Lamp
replacement
notification
lit flashing off
Indicator is lit or flashing green or orange Normal
If you press the button, projection will start after warm-up is complete.
The lamp is near the end of its operating life. Replace the lamp with a new one as soon as possible.
If you continue to use the old lamp, the possibility that the lamp may break will increase.
Orange
Red
Green
Orange
Red
Red
Orange
Green
Orange
/