56 - Menu Operations
5Select the parameter value.
Press the [Tracking +, -] button on the projector (tilt the [Enter] button left or right on the
remote control) to select the parameter value.
Point
·(Enter) is attached to the rear of the sub item names that execute the parameters and
continue onto the lower hierarchies. Press the [Enter] button to set this selection, and then
select the parameter setting again.
·Refer to the list of settings for further information on the function of each setting. (see
page 57)
6Set all of the other items in the same way.
7Press the [Menu] button.
The menu will end.
Point
·Press the [Esc] button to return to the previous menu in the hierarchy.
·The items displayed on the image menu will differ in accordance with the projected input
source, and menus other than that belonging to the projected input source cannot be
adjusted.
·Image menus cannot be adjusted when no image signals are being input.
·The last setup screen will be displayed when a menu is ended and then displayed again
(the same status as immediately prior to ending the menu with procedure #7.)
Language
Startup Screen
Color Setting
Comp2Sync Termination
Rear Proj.
Ceiling
Reset
Select [English]
Execute
:
:
:
:
Auto Manual
ON OFF
ON OFF
ON OFF
ON: OFF
Select