PSB No: P-0077

Page: 9 of 11

EPL-7000 cont.

[S] WARMING UP

The printer is warming up.

Note:

If any of the following messages appear, turn the printer off for at least five seconds, then turn it back on. If the same message is displayed, repair is required.

SCAN MOTOR ERROR

HSYNC ERROR

HEATER LAMP ERROR

MAIN MOTOR ERROR

FAN MOTOR ERROR

ES300C Display Codes

E-C Command error. An unidentified command or parameter was detected.

E-l Interface error

a. Incorrect communication parameter received. b. Broken connector or wire.

c. Host failed to respond within 30 seconds. d. Host is not accepting data. (DSR= Low)

E-F Fatal error

a. A lamp is broken.

b. Power is applied before the transportation screws were removed. c. System failure

GQ-3500 Display Codes

 

do

Cover Open error

EO-00

Engine driver CPU error.

EO-01

Option tray CPU error.

EO4+02

Option tray motor error.