5.Place the paper on the paper guide with its left edge next to the edge tab as shown in Figure 1-10 below. Push the paper firmly into the printer, then let go of it.

6.Pull the paper bail lever forward to the single-sheet loading position (indicated by the icon). This makes the paper feed into the printer until it is past the paper ball.

7.When the paper stops, push the paper bail lever back to the printing position. This makes the paper feed backward until only its top edge is under the paper bail.

If the platen (the black roller) turns but the paper does not load, remove the paper from the printer and try again, starting at Step 3. This time press the paper a little more firmly into place.

If nothing happens at all, see that the printer is turned ON and that the ON LINE light is off. Then remove the paper and try again.

Figure 1-1O.

Aligning the paper

Paper bail

1-10

Setting Up the Printer