PSB No:
Page: 3 of 5
Q7. How do I set the EPL- 6000 back to the factory - default settings using the SelecType buttons on the printer’s front panel?
A.Set the printer to OFF- LINE, then press the SelecType button. The next step is to press and hold the “RESET/CONTINUE” button for approximately 3 seconds, when “INlTlALlZE” appears on the LCD display release the button. The final step is to press and hold the “RESET/CONTINUE” button again for approximately 3 seconds, when “RESET” will appear on the display release the button. The printer has now been reset to the factory- default settings.
NOTE: lf the INTERFACE, DATA BUFFER, ‘or OVERLOAD BUFFER settings are changed the printer must also be powered “OFF” then back “ON” in order for these changes to become active.
Q8. Why does the EPL- 6000 display “DATA IN BUFFER” on the LCD and not print anything when I send data to it?
A.The EPL- 6000 is a page printer meaning that it prints a whole page at a time. If the EPL- 6000 doesn’t receive a full page of data or a FORM FEED command from the software it will not print
Q9. HOW do I eject the page from the EPL- 6000 when “DATA IN BUFFER” is shown on the LCD display?
A.Press the “RESET/CONTINUE” button to eject the page.
Q10. Where can I purchase a Technical Reference Manual (programmer’s manual) for the
A.A Technical Reference Manual for the HP LaserJet Series II printer can be purchased directly from HP’s Direct Marketing Department. The phone number for HP’s Direct Marketing Department is
Q11.
A.
Why does the EPL- 6000 beep and display “ERROR 20” several times when I attempt to use downloaded (soft) fonts?
An “ERROR 20” message indicates you have exceeded the printer’s available user memory. A solution to this would be to add more user memory to the EPL- 6000. The P/N for the optional 2MB memory board is IBS401.