PSB No: P-0077

Page: 6 of 11

EPL-7000 cont.

[E] REMOVE CARD

You may have inserted a font card or cartridge while the printer was on line or while the FEED light was on. Data still remains in the printer’s buffer.

[E] RESELECT TRAY

The optional lower paper cassette is not installed and the INPUT option is set to OPT or AUTO.

[S] RESET

The printer is being reset to the previous settings in the macro specified with LOAD MACRO option in SelecType Level 1.

[S] ROM Check

The printer is checking ROM.

[E] SAVE MEMORY OVERFLOW

lf this message appears when you are trying to save a macro with the SAVE MACRO option in SelecType Level 1, the printer does not have enough memory to save any additional macros

[E] SERVICE REQ. CXXX

A controller error has been detected.

[E] SERVICE REQ. EOOXX

A print engine error has been detected. XX= 03 Fusing Unit (low temp)

04 Main Drive Motor

05 Ozone Fan motor

06 Polygon Mirror Drive

09 HSync Signal

[E] SET FULL PRINT

This message may appear when you are trying to print graphics or a mix of text and graphics.

[S] STANDBY MODE

When both CH P and CH S remain off for about thirty minutes, the printer enters standby mode and this message appears.

[E] STARTUP ERROR

lf this message appears when you turn on the printer, the power may have been turned off while the printer was performing a save or reset operation.