note
You can also set up your image as a startup screen. Use the Advanced menu to enable the startup screen; see page 46.
6.When you see the message “Select this image?” select Yes and press Enter. If you want to change the area selected, select No, press Enter and repeat steps 4 through 6.
7.Use the directional buttons on the remote control to select a zoom rate (display size), and then press Enter.
8.When you see the message “Save image as user’s logo?,” select Yes and press Enter. Saving the logo may take a few minutes. Do not use the projector or other sources (computer, video, etc.) while the logo is being saved.
9.When you see the message “Completed,” press Esc or Menu.
Selecting When the Image DisplaysAfter your image is saved, you can set it up as the
1.Press the Menu button to display the main menu (if not already displayed).
2.Use the directional buttons to highlight Setting.
3.Press Enter to select the Setting menu.
4.Use the directional buttons to highlight
5.Use the directional buttons to select Logo; then press the Enter button. This sets your image as the screen displayed when the projector is not receiving a signal.
6.If you want to set up your image as the A/V Mute display, use the directional buttons to move down to A/V Mute.
7.Use the directional buttons to select Logo; then press the Enter button. This sets your image as the screen displayed when you press the A/V Mute button.
8.When you’re finished, press Esc or Menu.
To test your setting, press the A/V Mute button to display your image. Press it again to turn off the image.
44