Epson pro5k, pro5k u1 •In direct sunlight or dusty conditions, •In an area with high temperature or humidity, NOTE: Be sure to follow the Safety Instructions in the Introduction

NOTE:

CAUTION:

11-2 Setting Up the Printer

The printer weighs approximately 50 lb. Do not try to lift or carry the printer alone.

The RS 5000 is packed in a separate box. See the RIP Station 5000 Setup Guide for unpacking and setup instructions. The optional lower paper cassette is also packed in a separate box.

TO UNPACK THE PRINTER:

1.Follow the instructions on the Notice Sheet to remove the tape and protective materials.

Save all packaging so you can use it if you need to transport the printer later.

2.Locate the printer on a flat, stable surface near a grounded outlet.

Do not use an outlet controlled by a wall switch or timer, or the same circuit as a large appliance. This may disrupt the power, which can erase the printer’s memory and damage the power supply.

3.Leave plenty of room in back to access the manual feed slot and enough room in front for removing the paper tray.

4.Do not put the printer:

•In an area with high temperature or humidity•In direct sunlight or dusty conditions

•Near sources of heat or electromagnetic interference, such as loudspeakers or cordless telephone base units

NOTE: Be sure to follow the Safety Instructions in the Introduction.

If you purchased the optional lower paper cassette, you need to place the printer on top of it. Follow the instructions in the next section to install the lower cassette.