Epson Stylus Photo RX600
3.Open the ink cartridge cover holder by pulling the back up and toward you.
Caution:
Never attempt to open the cartridge holder’s cover while the print head is moving. Wait until the cartridges have moved to the replacement position.
Open the cover from the back
4.Identify the cartridge you need to replace. Press in the tab at the back of the cartridge to release it, then lift the cartridge straight out. Dispose of it carefully.
Note:
The illustration above shows the black cartridge being removed. Only remove the cartridge(s) you need to replace.
5.Unwrap the new cartridge.
6.Insert the new cartridge into the holder. Press down firmly until it clicks into place.
If you need to replace other ink cartridges, repeat steps 4 through 6 before continuing with step 7.
7. Close the cartridge cover, then lower the scanner unit.
Caution:
If you find it difficult to close the cover, make sure all the cartridges are firmly seated. Press down on each newly installed cartridge until you hear it click into place. Do not attempt to force the cover closed.
The RX600 begins charging the ink delivery system and the message Ink Charging appears on the LCD screen. When you see the message Ink cartridge replacement completed, click OK.
Caution:
Never turn off the RX600 while Ink Charging appears on the LCD screen, unless the RX600 hasn’t moved or made noise for more than 5 minutes. This may cause incomplete charging of ink.
Aligning the Print Head
If your printouts look grainy or vertical lines appear jagged, you may need to align the print head.
1.Make sure the RX600 is turned on and not printing, and the ! error light is off.
2.Load several sheets of plain
3.Press the Setup button to enter setup mode, then press the u and d buttons to select Head Alignment.
4.Press the OK button, then press OK again to print an alignment pattern.
16 - Epson Stylus Photo RX600 | 2/04 |