1-30 12. M odular Jack (MJ1/MJ2)
V-SFT Setting
1. The use of modular jacks 1 and 2 can be set on the V-SFT editor.
2. Select [Modular] from the [System Setting] menu. The [Modular Jack] dialog is
displayed. Select the use of modular jacks 1 and 2 from the following options.
*1 Refer to the next section “Transferring Screen Data.”
*2 Select this option when connecting the card recorder (CR EC).
*3 Refer to the next section “Barcode Reader Connect ion.”
*4 Select this option when connecting the serial extension I/O (V-I/O).
*5 Select this open when “Multi-link 2” is selected for [Connection] and “1” is set for [Local Port]
on the [Comm. Parameter] dialog.
*6 Select this option when connecting the temperature controller networ k or PLC2Way.
*7 Select this option for V-Link connection.
*8 Refer to “EU-01 (RGB input + sound output unit).”
*9 Select [Ladder Tool] when using the ladder transfer function with MITSUBISHI’s QnHCPU
port (Q mode) selected for the PLC type.
*10 Select this option for Modbus slave connection.
*11 Select this option when connecting the printer with serial interface. Refer to page 1-37.
Modular Jack 1 Modular Jack 2
[Editor Port]*1 [Not used]
[Memory Card]*2 [Memory Card]*2
[Barcode]*3 [Barcode]*3
[V-I/O]*4 [V-I/O]*4
[Multi-Link]*5 [Multi-Link]*5
[Temp. CTRL/PLC2Way]*6 [Temp. CTRL/PLC2Way]*6
[V-Link]*7 [V-Link]*7
[Touch Switch]*8 [Touch Switch]*8
[Ladder Tool]*9 [Ladder Tool]*9
[Modbus Slave]*10 [Modbus Slave]*10
[Printer (Serial Port)]*11 [Serial Printer (Serial Port)]*11