2-24 1. Operat ion of V7 Main Menu
4. Ethernet
The “Ethernet” screen is displayed by pressing the [IP Address (English)] switch on the
initial screen when transferr ing screen data via Ethernet for the first time, or by pressing th e
[Ethernet] switch on the Main Menu screen when transferri ng sc reen d ata to the V7 ser ies .
This screen is used for setting the IP address (a number that identifies the V7 serie s on the
network) that is indispensable for Ethernet communications.
Depending on whether the LAN (10BASE-T) connector at V7i or the communication
interface unit CU-03 for V7 is used, the “Ethernet” screen contents and the required
settings vary as described below.
Connection with LAN (10BASE-T) Connector at V7i
*1 Network Table
Register IP addresses and other information for the V series, PLCs or computers that should be
included for Ethernet communications on the V-SFT editor. ([System Setting] → [Network Table
Setting] → [Ethernet] → Edit Network Table) The registered network table can be used or not
used depending on the [Not Use Network Table/Use Network Table] switch.
Return
<-
Ethernet
Not Use Network Table
It is not used when the gate way or the sub-mask is zero.
IP Address:
Gate Way:
Sub-mask:
Port No.
Connect
->
Setting
Finished
00 0
0
0
000
10000
000
0
Cursor switches
[Increment/Decrement] switch for the value
in the cursor position
Determines the setting such as IP address,
and moves back to the Main Menu screen.
Used for checking the 10BASE-T interface.
Normal: Connect
Error: Disconnect
Moves back to the Main Menu screen or
the initial screen.
Selects [Not Use Network Table] or [Use Network Table].
*1
Network table
number