Chapter 1

Running the Diagnostics

This chapter describes how to start and use the diagnostics programs.

Starting the Diagnostics

To start the diagnostics programs, follow these steps:1.Turn off the computer and wait for a few seconds.2.Place the diagnostics diskette in drive A, and secure the disk drive.3.Turn on the computer.The computer tests itself, and then automatically starts the diagnostics.

The Power-on Self Test

Whenever you turn on or reset the computer, the system performs some built-in diagnostics called the power-on self test. This test checks the RAM (random access memory), keyboard, system board, and peripherals before the computer begins normal operation. For a complete description of the power-on self test, refer to Appendix B.

If the self test encounters a problem, you see an error message. The error messages are described in Appendix B.

If the self test finds a discrepancy between the equipment installed on the computer and the equipment list maintained by the computer, an error message displays. You can run the SYSTAT program (described in Chapter

7)to see the list of equipment installed and to check the current settings for your configuration.

1-1