Ericsson LBI-39224 manual Diagnostics Dialog Box, GSC Translation Option Selected

LBI-39224

GSC Translation

This option, also accessible from the Diagnostics Options menu, is similar to the GSC Data option except there is an attempt to translate the messages into a more readable format. This is similar to the Call Translation option, except no messages are filtered out. Messages that cannot be translated are left in the raw hex form. A typical screen is shown below. Note the header for this option is identical to the Call Translation header since many messages fall into the same format.

Figure 52 Diagnostics Dialog Box, GSC Translation Option

Selected

GSC Translation should be used when it is desired to view switch/site status while tracing a problem call if the approximate time is known, for example: Failsoft state at time of call. This is recommended since even a very low traffic CEC/IMC will generate more than 3000 messages in a 15-minute period under these conditions.

NOTE

The buffer at the MOM controller will wait until it is about 65% full before writing to the data log file. This could mean a delay of up to 5 minutes between keying a call and the call showing up in the data log.

4-17