Settings (Video)

Video adjustment

[VIDEO q Video Adjust]

1Highlight the Video Adjust menu item and press the ENTER button.

Video Adjust

Progressive Setting

Move

Return

Select

Exit

Reference*

Memory 1

Memory 2

Memory 3

Move

Return

Select

Exit

Near the bottom of the display, a row of four options appears: Reference, and three memory settings (Reference contains the factory default settings and the three memories can be used to make video settings for different monitors, types of program material, etc.).

Usually, you will not need to change these settings, but there may be occasions when you want to alter one or two parameters for a perfect picture.

2To change settings, use the left and right cursor buttons to highlight one of the Memory settings, and press

ENTER.

<Selecting the Reference setting returns you to the VIDEO menu.

3Use the up and down buttons to select the parameter, and the left and right buttons to change the value.

Sharpness

Adjusts the sharpness of the picture shown on the monitor.

Contrast

Adjusts the picture contrast

Brightness

Adjusts the brightness of the picture

Gamma

Adjusts the gamma value of the picture

Hue

Adjusts the green/red balance of the picture (only for progressive-scan and S-Video output)

Chroma Level

Adjusts the chroma level of the picture

Chroma Delay

Sets the delay between the Y and C signals (only affects progressive-scan pictures).

Black Setup

Use this to enhance the black level of the picture, to assist in the “3D look” of some scenes. Normally, this setting should be 0 IRE. Change it only if really necessary.

4Press RETURN when done, to return to the memory selection screen, or SETUP to exit the setup menu completely.

<Sharpness, Gamma and Hue have no effect on the video signal output from the HDMI terminal.

ENGLISH

33