Extron electronic 200, 300C, 300S, 600, 800, Cable Cubby 200, Cable Cubby 600, Cable Cubby 800

Cable Cubby® Products • Packaging for Shipment

Packaging for Shipment

Cable Cubby® Products • Packaging for Shipment

B-2 B-3

The Cable Cubby’s ultra-ﬁ ne machined surfaces and moving

parts make them vulnerable to damage caused by mishandling

during shipment if they are improperly packaged. If, for any

reason, you need to return a Cable Cubby to Extron, ﬁ rst contact

Extron to obtain a return kit. The return kit, which reduces the

chances of damage during shipment, includes a sturdy shipping

carton and foam that can be ﬁ tted to each Cable Cubby model

(ﬁ gure B-1).

Figure B-1 — Cable Cubby return kit

Package a Cable Cubby for shipment as follows:

1. Contact the Extron S3 Sales & Technical Support Hotline to

obtain a return kit. Extron will send the return kit to the

location you specify.

W The ﬂ anged edges of the top of the surface enclosure

are sharp when the Cable Cubby is removed from

the table. Exercise caution when handling to

prevent personal injury.

C The ﬂ anged edges of the top of the surface enclosure

are bevelled to an ultra-ﬁ ne thickness of less than

0.04 (4/100)” (approximately 1 mm). These

edges are soft and can be easily nicked or bent.

Exercise caution when handling and mounting the

enclosure. Mishandling can damage the appearance

of the enclosure.

2. Disconnect and retain all cables, remove and retain the

AAP shelf assembly(s) (CC 300, 600, 800) and remove

the Cable Cubby from the table or desk. See Removing

and Replacing the Cubby, steps 1 through 4, in chapter 3,

Maintenance and Modiﬁ cations.

N For Cable Cubby 300, 600, and 800 models, retain the

screw clamps.

3. Install the plastic strips that protect the ﬂ anged edges of

the top of the surface enclosure (ﬁ gure B-2).

Figure B-2 — Installing protective strips

N For Cable Cubby 200 models proceed to step 13.

For Cable Cubby 300, 600, and 800 models, continue to

step 4, below.

4. Remove and retain the top foam pad from the carton.

5. CC 300, 600, 800 only — Remove and discard the center

foam section of the cushion in the carton (ﬁ gure B-3). If

you are returning a Cable Cubby 300 model, this is the

correct ﬁ t. Proceed to step 8.