IN1606 and IN1608 Series Scaling Presentation Switcher • Operation 16
Menu Overview
In the OSD menu, the IP address and firmware version are displayed in the top border. The
active input settings and output resolution are displayed in the bottom border. The OSD
menu contains nine submenus with various submenu items of adjustable settings or device
information. Use the Menu, Enter, and Navigation buttons to navigate the OSD menu.
To open the OSD menu:
1. Connect a display device to an HDMI output connector (see h on page 11).
2. Press the Menu or Enter button to open the OSD menu.
To navigate the OSD menu:
1. Press the Up or Down button to navigate the nine submenus. The following table shows
the nine submenus and their respective submenu items.
Submenus Submenu Items
Quick Setup Auto-Image Input Format EDID Output
Resolution
Audio Mute Test Pattern DHCP IP Address
User Presets Recall Save Clear
Picture Controls Image
Position
Image Size Brightness/
Contrast
Color/Tint Detail
Input Auto-Image Input Format Film Mode Horizontal/
Vertical Start
Horizontal/
Vertical
Active
Total Pixels/
Phase
HDCP
Authorization
EDID
Output Resolution HDMI “A”
Format
HDMI “B”
Format
DTP “C”
Format
(IN1608)
HDCP
Notification
Audio Audio Mute Audio Format Gain Mic/Line
1 Gain/
Phantom
Mic/Line
2 Gain/
Phantom
Mic/Line
Volume
Program
Volume
Output 1/2
Format
Advanced Test Pattern Screen
Saver/
Timeout
Auto-Image Aspect Ratio Auto Memory Overscan Auto Switch Factory
Reset
Communication Remote Port MAC
Address
DHCP IP Address Subnet Mask Gateway
Device Info
(Read Only)
Unit Name Firmware Temperature Active Input
Details
Active Output
Details
Detected
Displays
NOTE: The Communication submenu is normally locked. Press and hold the Enter
button for 10 seconds to unlock the submenu items.
2. Press the Enter or Right button to open submenu items.
3. Press the Up or Down button to navigate the submenu items.
4. Press the Menu button to exit a submenu item or return to the previous submenu.
To adjust a submenu item:
1. Navigate to an adjustable item and press the Enter or Right button to select the
submenu item.
2. Press the Left or Right button to select a submenu item or a specific adjustable setting
within the selected submenu item.
If the selected submenu item has multiple adjustable settings, press the Up or Down
button to select a value.
3. Press the Enter button to accept the new value.
Press the Menu button to cancel any pending changes.
To exit the OSD menu:
Hold the Menu button for 3 seconds to exit the OSD menu.