IN1606 and IN1608 Series Scaling Presentation Switcher • Configuration Software 57
Connect
This option connects a device tab in emulation mode to
a device. The page goes from emulation mode to live
mode and current device settings are displayed. The tab
indicator changes from gray (not connected) to green
(connected).
NOTE: If a device is already connected, the Connect
option is disabled until the device is disconnected or
the connection times out.
1. From the Connections menu, select Connect. The
Connection Settings window opens (shown at right).
2. Select the connection method from the list of radio
buttons.
• Select the TCP/IP radio button if the device is connected to the host device
through a LAN or WAN.
Enter the device IP address or hostname in the IP Address field. If the device is
password-protected, enter the password in the Password field.
• Select the RS-232 radio button if the device is connected to the host device
through an RS-232 connection.
Select the desired values from the COM Port and Baud Rate drop-down menus.
NOTE: The default baud rate is 9600.
• Select the USB radio button if the device is connected to the host device through
the front panel mini-USB connector. Select the device from the list of devices.
3. Click the OK button to connect to the device.
Disconnect
This option disconnects the PCS program from the connected device and returns it to
emulation mode.
From the Connections menu, select Disconnect. The scaler tab enters emulation mode.
NOTE: If a device is already disconnected, the Disconnect option is disabled until the
device is connected.
Exit
This option disconnects the scaler from the software and closes the application.
From the Connections menu, select Exit. The application closes.