Hardware Features and Installation, cont’d
IPL 250 • Hardware Features and Installation
2-6
Rear Panel Features and Connections
INPUT
LAN
POWER
12V
500mA
MAX 1234 COM 3 IR
3
SGSG
TXRX 4RELAY
34
COM1
TXRX
RTS CTS
COM 2 IR
1
SGSG
TXRX 2RELAY
12
MAC: 00-05-A6-XX-XX-XX
S/N:
1 2 7
38 4 5 6
a Power connector (page 2-6)
b LAN (Ethernet, IP) connector
and LEDs (page 2-6)
c COM1 configurable RS-232 port
(page 2-7)
d COM2 and COM3 RS-232 ports
(page 2-7)
e IR output ports 1-4 (page 2-8)
f Relay ports 1-4 (page 2-9)
g Input (contact input) ports
(page 2-9)
h MAC address — (page 2-9)
Power connection
a Power connector — To power the IPL, connect a cable between this port and
the included 12 VDC, 1 amp (maximum) power supply. The Extron power
supply included with the IPL is ready to plug in. Wiring is shown in the
following diagram.
Bidirectional control and communication connections
b LAN (IP) connector and LEDs — To connect and to control the IPL and the
devices connected to it in an Ethernet network, plug a cable into this RJ-45
socket and connect the other end of the cable to a network switch, hub, router,
or PC connected to an Ethernet LAN or the Internet.
• For10Base-T(10Mbps)networks,useaCAT3orbettercable.
• For100Base-T(max.155Mbps)networks,useaCAT5cable.
You must configure this port before using it.
Activity LED — This yellow LED blinks to indicate
network activity.
Link LED — This green LED lights to indicate a good
network connection.
2-Pole Captive Screw
Connector
Tie Wrap
3/16”
(5 mm) Max.
SECTION A–A
Ridges
Smooth
Power Supply
Output Cord
A A
LAN
RJ-45
Port
Link
LED
Activity
LED