SCP/AAP A, SCP 200, SCP 250 • Dimensions, Templates, Labels
SCP/AAP A, SCP 200, SCP 250 • Dimensions, Templates, Labels
Dimensions, Templates, and Labels, cont’d
SCP 200 template
This full-size template is a guide for cutting a hole for the
2-gang size electrical box for the SCP 200 or for the SCP 200
itself (if it will be installed directly into furniture or wall).
The light gray area represents the layout of the
electrical box (3.75"H x 3.75"W) against the rear
of the SCP 200 front panel.
The dashed line indicates the cut-out
area (3.95"H x 3.95"W) for installing
the electrical wall box.
To install the control panel
without
a wall box,
use the cut-out area (3.00"H x 3.70"W)
indicated by the dotted line.
B-7
Templates
Use the templates as a guide to mark and cut the hole in the wall
or furniture through which the SCP control pad will be installed.
The templates include the recommended 0.1” (0.25 cm)
clearance on all sides of the electrical wall box to allow room for
the raised areas surrounding the knockouts. See the installation
chapter for details on installing the control pads.
SCP/AAP A template
The SCP/AAP A will usually be mounted in an AAP faceplate/
bracket or an architectural series interface, distribution
amplifier, or other device. The full-size template below can be
used if you are going to install the SCP/AAP A directly into
furniture.
VOLUME
The light gray area
represents the
SCP/AAP A's
circuit boards.
To install the SCP/AAP A
without
a wall box
or an AAP bracket, use the cut-out area
(2.7"W x 2.05"H) (6.9 cm W x 5.2 cm H)
indicated by the dotted line.
B-6