Extron electronic SW RGBHV Series

QS-1SW RGBHV Series Switchers • Quick Start

Quick Start — SW RGBHV Switchers

Installation

Step 1 — Remove power

Turn off power to the input and output devices,

and remove the power cords from them.

Step 2 — Mounting

SW2 —

If desired, mount the switcher in a rack using an

Extron 1U Universal Rack Shelf, part # 60-190-01 or

60-604-02.

If desired, mount the switcher under a desk using

an Extron Under-desk Mount Kit, part #70-077-01.

If desired, mount the switcher through a desk using

an Extron Through-desk Mount Kit, part #70-077-02.

SW4 or SW6 —

If desired, mount the switcher in a rack with the

supplied rack ears.

If desired, mount the switcher under a desk using

an Extron 1U Under-desk Mount Kit,

part #70-222-01.

Step 3 — Video Inputs

Connect up to 2, 4 or 6 RGBHV, RGBS, RGsB, or

RsGsBs video or component video inputs to the

Input connectors (3).

Step 4 — Video Output

Connect an RGBHV, RGBS, RGsB, or RsGsBs video

or component video display or other device to the

Output connectors (3).

RGBHV

RGBS

RGsB,

RsGsBs,

Component

BH/HV V

RGBH/HV V

Unbalanced Input

Tip

Sleeve

Tip

Sleeve

Balanced Input

Tip

Ring

Sleeve (s)

Tip

Ring

(high impedance) (high impedance)

Step 5 — Audio Inputs

Cable audio models for stereo audio input (5).

High impedance is generally over 10k ohms.

Step 6 — Audio Outputs

Cable audio models for stereo audio output (6).

Step 7 — Remote Control

Connect a host device, such as a computer or touch

panel control via RS-232, OR connect a remote

contact closure device to the switcher via this

9-pin D connector (7) for remote control of the

switcher.

To command a switch under contact closure

control, momentarily short an input’s pin on the

remote connector to ground (the switcher must be

in normal [manual] mode).

See chapter 4, “Remote Control”, for definitions of

the SIS commands and details on how to install and

use the control software.

Step 8 — Connect power

Plug the switcher, input devices, and output

devices into a grounded AC source, and turn on the

input and output devices.

Unbalanced Output

Tip

See caution

Sleeve

Tip

See caution

Balanced Output

Tip

Ring

Sleeve (s)

Tip

Ring

CAUTION

Connect the sleeve

to ground.

Connecting the

sleeve to a negative

(-) terminal will

damage the audio

output circuits.

Pin RS-232 Contact

closure Function

1 — In #1 Input #1

2TX —

— Transmit data (-)

3 RX Receive data (+)

4 — In #2 Input #2

5 Gnd Gnd Signal ground

6 — In #3

In #4

In #5

In #6

Input #3

Input #6

Input #4

Input #5

7—

8—

9—

Female

Male