REPLACING HALOGEN BULBS

Fire Magic¨ Echelon grills are all engineered with the conveniences of electrical power for illuminating and igniting the grill.

To replace any Echelon oven light, follow the instructions below.

WARNING

To protect from potentially sharp sheet metal and glass, wear gloves and safety glasses during this procedure.

1.Turn all burner control knobs to the OFF position and shut off the gas supply to the grill at the source (tank valve for propane units or gas line shut-off valve for natural gas units.)

2.Disconnect supply of external electrical power to the grill.

CAUTION: Wait for the grill, oven, lens, light bulb, and Þ xture to cool before proceeding to the next step.

3.Open the oven lid.

Important: Place one hand directly below the glass lens and prepare to catch it when it is detached.

4. Carefully insert a standard ß at head screwdriver or thin plastic spatula between the glass lens and the stainless steel on which the light is mounted

Fig. 28-1

Lens

and gently pry the glass lens out in such a way that the stainless steel is not scratched (twisting the screwdriver handle, for instance). Catch the lens and set it safely aside.

Note: You may wish to take this opportunity to clean the lens with a standard household window cleaner and then dry it completely.

5.Wearing a pair of gloves, reach into the Þ xture, gently grab the bulb, and pull it straight out of the Þ xture so that the two pins at the base of the bulb come all the way out.

Fig. 28-2

Bulb

Socket

Fixture

Curved cut-out top of lens

Important: Bulb is halogen. DO NOT TOUCH with bare hands. Oils from hands drastically reduce bulb life.

Note: It may be helpful to rock the bulb gently backward and forward while pulling it out.

Fig. 28-3

Socket

Holes

Prongs

Bulb

6.Inspect the old bulb for broken glass or Þ lament.

Note: It may be beneÞ cial to test a suspect bulb in one of the other light Þ xtures known to be working and turn the power back on to be certain the bulb is actually not working.

7.Insert the new bulb into the socket so that both pins slide all the way into the two holes in the bottom of the socket.

8.Place the lens back into the Þ xture opening with the curved cut-out on the bottom and snap it back into place.

28