First Virtual Communications 065-7710 2. Installation

Signamax ™ 065-7710 8-Port 10/100BaseT/TX + 2SFP Managed Switch
Publication date: January, 2006
Revision A1 10
2. Installation
2-1. Starting 8 Fast Ethernet + 2 Gigabit L2 Managed Switch Up
This section will give users a quick start for:
- Hardware and Cable Installation
- Management St ation Installation
- Software booting and configuration
2-1-1. Hardware and Cable Installation
At the beginning, please do first:
⇒ Wea r a grounding device to avoid the damage from electrostatic discharge
• Installing Optional SFP Fiber Transceivers to the L2 Mana ged Switch
Note: If you have no modules, please skip this section.
• Connecting the SFP Module to the Chassis:
The optional SFP modules are hot swappable, so you can plug or u nplug it
before or after powering on.
1. Verify that the SFP module is the right model and conforms to the
chassis
2. Slide the module along the slot. Also be sure that the module is pro perly
seated against the slot socket/connector
3. Install the media cable for network connectio n
4. Repeat the above steps, as needed, for each module to b e installed into
slot(s)
5. Have the power ON after the above procedures are done
Fi
g
. 2-1 Installation of O
p
tional SFP Fiber T ra nsceive
r