INSTALLATION
Continued
CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to HI, check toseeifflamescontactanylog.If so, reposition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
WARNING:Failuretoposition thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
INSTALLING LOGS
Dual Burner Biltmore Split Oak Models CCL3018PTA/NTA, CCL3924PTA/NTA Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place front log (#1) on grate fingers. Make sure front log rests firmly between grate fingers and grate base (see Figure 17).
2.Place base of middle log (#2) in
middle log should fit over burner (see Figure 18). Make sure front of middle log is resting on tabs of grate base.
3.Locate pins on bottom of back log (#3). Slide these pins into holes in grate base behind burner (see Figure 19).
Middle
Log (#2)
Burner
Tab | |
|
Figure 18 - Installing Middle Log #2
(CCL3924PTA/NTA Shown)
Pins
Rear
Log (#3)
Hole in
Grate Base
Burner
Front
Log (#1)
Figure 19 - Installing Rear Log #3
(CCL3924PTA/NTA Shown)
Grate
Fingers
Grate
Base
Figure 17 - Installing Front Log #1
(CCL3924PTA/NTA Shown)
4.Locate holes on bottom of crossover log (#4). Slide front hole onto left pin (CCL3924PTA/ NTA) or middle pin (CCL3018PTA/NTA) on middle log (#2) and pin on back log (#3).
See Figure 20 on page 17, for placement.
5.For CCL3924PTA/NTA Only: Locate pin and hole on bottom of crossover log (#5). Slide pin into hole located in crossover log (#4). Slide hole onto pin on front log (#1). See Figure 21 on page 17.
16 | www.fmiproducts.com |