FMI VSGF36NRC, VSGF36PRC 5

	PRODUCT IDENTIFICATION
	Rear	Top Outer Casing
		Top Louver
	Burner
Log Set		Assembly

Fireplace

Hood

Front

Remote Burner

Control	Base
	Base
	Assembly	Screen
Figure 1 - Log Base Assembly		Screen
Figure 1 - Log Base Assembly		Assembly
		Assembly

Bottom Louver Assembly

Figure 2 - Fireplace

UNPACKING

CAUTION: Do not remove data plates attached to heater base assembly. The data plates contain important warranty and safety information.

1.With utility knife, cut carton all the way around above staples on bottom tray. Lift carton off of heater. Remove packing.

Note: Hood is located on top of fireplace in a carton.

2.Locate one screw above top left corner of fireplace screen. Remove and discard screw. Lift fireplace screen up and pull out to remove.

3.Remove protective packaging applied to logs, log base assembly and fireplace.

4.Check heater for any shipping damage. If heater is damaged call FMI PRODUCTS,

LLC at 1-866-328-4537 for replacement parts before returning to dealer.

PRODUCT FEATURES

OPERATION

This vent-free fireplace is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic flames and glowing embers. When used without blower, fireplace requires no electricity making it ideal for emergency backup heat.

SAFETY DEVICE

This fireplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff sys- tem. ODS/pilot is a required feature for vent- free room heaters. ODS/pilot system shuts off fireplace if there is not enough fresh air.

IGNITION SYSTEM

This fireplace has an electronic ignitor to light heater fuel supply.

REMOTE CONTROL

This fireplace is equipped with a thermostat remote control. Remote can also be used manually. Use this remote to control temperature and flame height.

121082-01K