Fujitronic UG520H-x

Appendix - 1

Up until now it was necessary to debug the data by removing and mounting "connection cable between PC

and PLC" and "connection cable between POD and PLC." When using the ladder transfer function, it is

possible to write ladder programs or monitor the PLC memory via POD connected to PC without removing

and mounting each cable.

Applicable PLC

Ladder Transfer Function

(Transparent Mode)

Select PLC Type CPU Ladder comm. prg I/F DRV

QnH(Q) series CPU Q02(H), Q06H MelQHCpQ.lcm

QnH(Q) series link Q00, Q01 MelQnA.lcm

FX series CPU FX1/2, FX0N

MelFx.lcmFX2N/1N , FX2NC

FX1S FX1S series CPU

FX2N series CPU

MelQHCpQ.tpb (1.240)

MelQnA.tpb (1.300)

MelFx.tpb (1.300)

Applicable Types

• UG221, UG320, UG420, UG520, UG420H-E

* This function cannot be supported with 1:n communication (multi-drop), multi-link and multi-link2

communication.

• The following types are unavailable for this function.

UG220, UG320HD

Version and Main Menu Screen

Available versions are as follows. The information can be shown on the [Main Menu] screen.

Main Menu

System Information

Screen Data

Information

Screen Data

Information

Size :

PLC Type: MITSUBISHIAnA/N/U series

Comment:

Error: Stop

Time-Out: 0.50 sec

Retry: 3

Connection: 1 : 1 Baud Rate: 19200

Signal Level: RS232C Data Length: 7

PLC Stat.No.: 0 Stop Bit: 1

Parity: Even

Send Delay: 0msec

SYSTEM PROG. VER.1.000

FONT

VER.1.000/1.000/1.000

JAPANESE 32

I/F DRV VER. 1.000

MELSEC AnA/N/U

1998- 9- 1 07 : 23 : 30

Editor : MJ1

Memory-Card

I/O Test

UG420H-TC1

786432

Extension

Editor:- - -

Main Menu

Extension Program Info.

Ladder Comm. Program

VER. 1.000 MELSEC QnH Q

CPU Port

SYSTEM PROG.

FONT

ITEM Version

VER.1.280 or later

VER.1.210/1.130/1.000 or later

Pressing the [Extension] switch brings to the

[Extension Program Info.] screen.