Fujitsu DL3750+/3850+ manual Paper Handling Problems and Solutions

TROUBLE-SHOOTING

Table 7.1 Print Quality Problems and Solutions (Cont.)

Problem	Solution
If an error occurs	If an error occurs during printing with Windows,
during printing with	execute reset from the control panel or turn off the
Windows, simply	printer, then print the page again.
printing the page
again will cause the
printed characters
to be garbled.

Paper Handling Problems

Table 7.2 describes common paper handling problems and suggests solutions.

See Chapter 3 for detailed procedures on loading and using paper.

Table 7.2 Paper Handling Problems and Solutions

Problem	Solution
Paper cannot be	Make sure that the paper select lever is set
loaded or fed.	correctly. Move the lever backward for continuous
	forms and forward for single sheets.
	Make sure that the paper covers the paper-out sensor,
	i.e., the left paper edge is within 52 mm for single
	sheets or 41 mm for continuous forms from the left
	edge of the platen. (This problem cannot occur if you
	use the forms tractor unit or insert a single sheet with
	its left edge in contact with the left paper guide.)
	Make sure that the paper holder is closed and forms
	tractors are positioned correctly to match the width of
	your paper.
	Make sure that the printer does not detect the paper
	after you have ejected the loaded paper manually.
	If the printer detects paper even though it has already
	been ejected, press the LOAD button and have the
	printer perform the paper ejection operation, then load
	the paper again.

7-4 User's Manual