Manuals / Brands / Computer Equipment / Scanner / Fujitsu / Computer Equipment / Scanner

Fujitsu FI-6000NS Chapter 2 Setting up the Scanner, 2.1 Space Requirements, 2.2 Installing the Scanner, 2.3 Connecting the Cables

1 35

Download 35 pages, 1.32 Mb

Chapter 2 Setting up the Scanner

2.1 Space Requirements

The following space is required to set up the scanner: Depth: 700mm

Width: 400mm

Height: 500mm

2.2 Installing the Scanner

	When lifting the scanner, always
	hold it by the indentations on the
	bottom of each side to ensure a
	stable grip.

Holding the scanner in any other way may cause it to be dropped or damaged.

2.Connect the AC adapter connector to the scanner's DC inlet.

3. Connect the LAN cable to the LAN connector.

1.Place the scanner at its installation site.

2.Attach the ADF paper chute.

Hold the ADF paper chute and insert its tabs into the corresponding slots in the scanner as shown in the following figure.

The side guides of the ADF paper chute should face up.

Tab

2.3 Connecting the Cables

1. Connect the AC cable to the AC adapter.

ATTENTION	Use only the AC adapter provided by the
	manufacturer.

4. Attach the back cover.

Attach the cover with the connected AC cable or LAN cable protruding out of the lower part of the cover.

5.Connect the other end of the LAN cable to the network hub.

6.Insert the AC cable into a power outlet.

⇒The power is connected but the scanner is not yet ready for operation.

Continue setting up the network.

4

Contents

Page Page Chapter Chapter 2 Setting up the Scanner Chapter 3 Setting up for Network Use Downloading the Manual Appendix A Calibrating the Touch Panel Appendix B Scanner Care Appendix C Replacing Consumable Parts Appendix D Network Connection Troubleshooting Copyright Page Page WinDump3.9.5 Introduction Use in High-safetyApplications About the Use of Mercury LCD Peculiarities Replacing Batteries Trademarks Manufacturer Symbols Used in This Manual About Maintenance Warning Indications Used in This Manual Warning Label ■Safety Precautions Do not damage the AC cable Use only specified AC cables and connector cables Do not touch the AC cable with wet hands Wipe any dust from the power plug Do not install the scanner on unstable surfaces Do not block the ventilation ports Do not place heavy objects or climb on top of the scanner Firmly insert the power plug Avoid any contact when scanner is in use Page Chapter 1 Scanner Features 1.1 Scanner Features 1.2 From Arrival through Operation 1.3 Checking the Contents of the Scanner Package 1.4Names and Functions of Parts Chapter 2 Setting up the Scanner 2.1 Space Requirements 2.2 Installing the Scanner 2.3 Connecting the Cables Chapter 3 Setting up for Network Use 3.1 Logging in 3.2Changing the Administrator Password 3.3 Setting the Scanner Name 3.4 Setting the Region/Timezone 3.5 Setting the IP Address/DHCP 3.6 Setting the DNS Server 3.7 Setting the WINS Server 3.8Checking the Network Connection 3.9 Restarting the System Chapter 4 Downloading the Manual Chapter 5 Performing a Scan Test ■If Scanning Completes Successfully ■If Scanning does not Complete Successfully Appendix A Calibrating the Touch Panel Appendix B Scanner Care Appendix C Replacing Consumable Parts Appendix D Network Connection Troubleshooting Appendix D ■Checking Basic Network Operation with a Ping Test ■Failure to Connect to a Remote Computer using its IP Address ■Failure to Connect to a Remote Computer using its Server Name ■Failure to Connect to the Scanner using a Web Browser ■Problems when Connecting to the Scanner using a Web Browser Appendix E Troubleshooting Network Scanner fi-6000NS Getting Started