Fujitsu (ISCSI) for VMware ESX

Chapter 6 Setting Up the VMware ESX Server

6.2 Setting Up for VMware Infrastructure 3

ETERNUS DX Disk storage systems User’s Guide -Server Connection- (iSCSI) for VMware® ESX

2Select the target iSCSI Software Adapter and click [Properties].

3Click [Configure] on the [General] tab.

4Select the [Status-Enabled] checkbox and click the [OK] button.

5Confirm that the [Enabled] checkbox is selected under "Status" on the [General]

tab and click [Configure] again.

6Confirm that the iSCSI name is displayed as follows and click the [Cancel]

button.

7Select the [Dynamic Discovery] tab and click the [Add] button.

8Enter the IP address for the iSCSI port of the connected ETERNUS DX Disk

storage system as the iSCSI server IP address, confirm that the port is set to

"Port 3260" (default), and click the [OK] button.

Contents

Main Page Preface The Contents and Structure of this Manual Acknowledgments Naming Conventions Page Table of Contents Chapter 7 Virtual Machine.......................................................................38 Chapter 1 Workflow Required Documents List Workflow Chapter 2 Checking the Server Environment Page Chapter 3 Notes 3.1 Connection Notes 3.1.1 For VMware vSphere 3.1.2 For VMware Infrastructure 3 3.2 VMware ESX Operating Notes 3.3 ETERNUS DX Disk Storage System Setup Notes 3.4 SAN Boot Notes 3.5 Server Startup and Power Supply Control Notes Chapter 3 Notes 3.6 LAN Switch Connection Notes Copyright 2012 FUJITSU LIMITED P3AM-3412-11ENZ0 3.6 LAN Switch Connection Notes Example of a LAN switch connection configuration Example of a network address configuration 3.7 Jumbo Frame Setting Notes 3.8 LAN Switch Setting Notes Page Chapter 5 Setting Up the ETERNUS DX Disk Storage Systems Chapter 6 Setting Up the VMware ESX Server This chapter describes settings related to the server iSCSI interface. 6.1 Setting Up for VMware vSphere 6.1.1 Turning on the Devices To turn on the connected devices, use the following procedures: Page Page Page 9 10 6.1.5 Enabling ALUA 1 2 IMPORTANT 3 4 5 the following command is executed in the terminal: Page 6 Page 4 Chapter 6 Setting Up the VMware ESX Server 6.2 Setting Up for VMware Infrastructure 3 6.2 Setting Up for VMware Infrastructure 3 6.2.1 Turning on the Devices To turn on the connected devices, use the following procedures: 1 2 3 4 5 Page Page Page Page Page Page 2 3 Chapter 7 Virtual Machine 7.1 For Windows 7.1.1 Setting the Disk TimeOutValue 1 2 3 4 7.2 For Linux 7.2.1 Applying Required Patches