Furuno 2837S, 2137S-BB installation manual Setting and Adjustment, DIP Switch Setting

3. SETTING AND ADJUSTMENT

3.1DIP Switch Setting

The processor unit is shipped for model FAR-2137S. If your model is FAR-2837S/2137S-BB, change the DIP switch setting as follows.

1.Remove the top cover of the processor unit.

2.Open the SPU assembly block and remove the shield cover.

Shield cover

SPU assembly block

SPU board 03P9337

DIP switch S1

3. Set the DIP switch S1 as follows.

�

OFF

1

2

3

4

S1

ON
	S1	Monitor SXGA for	Monitor UXGA for	FAR-2137S-BB
		FAR-2137S	FAR-2837S (For
		(Default)	MU-231CR
			S. No. 0269 and later)
	1	OFF	ON	OFF
	2	OFF	OFF	ON
	3		Not used.
	4

Note: Set #1 and #2 of S1 to OFF for MU-231CR S. No. 0268 and earlier.

3-1