Garmin Flight Deck 100 - page 61

190-00728-04 Rev. A
Embraer Prodigy® Flight Deck 100 Pilot’s Guide
49
SYSTEM OVERVIEW
Changing the arrival alert trigger distance:
1) Use the FMS Knob to select the AUX - System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the distance eld in the Arrival Alert Box.
4) Use the FMS Knob to enter a trigger distance and press the ENT Key.
5) Press the FMS Knob to deactivate the cursor.
flight Director
Two formats are available for the display of the flight director. Single Cue or X-Pointer may be selected.
To change the flight director format:
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the Format Active eld in the Flight Director Box.
3) Turn the small FMS Knob to display and highlight the desired flight director format and press the ENT Key.
4) Press the FMS Knob to deactivate the cursor.
Page navigation
The large FMS Knob displays the Page Group Tabs and navigates through the tabs. The small FMS Knob
navigates through the pages listed within a specific group. The number of clicks it takes to display the
Page Group Tabs and change to the next tab can be controlled from the Page Navigation box on the AUX
- System Setup Page.
OFF – Displays the Page Group Tabs with one click of either FMS Knob.
ON – Displays the Page Group Tabs and navigates to the next tab with one click of either FMS Knob.
The pilot can select, from the AUX - System Setup Page, the amount of time the Page Group Tabs are
displayed (in the lower right corner of the MFD). The timeout can range from two to ten seconds.
Selecting page navigation settings:
1) Use the FMS Knob to select the AUX - System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the ‘Change On 1st Click’ eld in the Page Navigation Box.
4) Turn the small FMS Knob to select ‘OFF’ or ‘ON’.
5) Turn the large FMS Knob to highlight the ‘Timeout Seconds’ eld in the Page Navigation Box.
6) Turn the small FMS Knob to select the desired number of seconds
7) Press the FMS Knob momentarily to remove the flashing cursor.
mfD Data Bar fielDs
The MFD Data Bar Fields Box on the System Setup Page displays the current configuration of the MFD
Navigation Status Box. By default, the Navigation Status Bar is set to display ground speed (GS), distance
to next waypoint (DIS), estimated time enroute (ETE), and enroute safe altitude (ESA).