ii
EPA POLLUTION PREVENTER
030.15218 Rev. B 7/95
FEDERAL COMMUNICATIONS COMMISSION
WARNING: This equipment was tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions in this manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. For more
information about radio frequency interference, refer to Appendix G of this manual.
CANADIAN REGULATIONS
This equipment is a Class A digital apparatus that complies with the Radio Interference Regulations, CRC
c. 1374.
IMPORTANT: Changes or modifications to this product not authorized by GCC Technologies Inc.
could void the FCC Certification and negate your authority to operate the product. This product was tested
for FCC Compliance under conditions that included the use of shielded cables and connectors between
system components. It is important that you use shielded cables and connectors to reduce the possibility
of causing interference to radios, television sets, and other electronic devices. You can obtain the proper
shielded cables from GCC Technologies or from an Authorized GCC Technologies dealer.
CLASS 1 LASER PRODUCT
LASER SAFETY: This printer is certified as a Class 1 laser product under the U.S. Department of Health
and Human Services (DHHS) Radiation Performance Standard according to the Radiation Control for
Health and Safety Act of 1968. This means that the printer does not emit hazardous radiation. Since
radiation emitted inside the printer is completely confined within protective housings and external covers,
the laser beam cannot escape from the machine during any phase of user operation. The Center for Devices
and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented regulations for
laser products on August 1, 1976. These regulations apply to laser products marketed in the United States.
The label on the printer indicates compliance with the CDRH regulations and must be attached to the laser
products marketed in the United States.
Caution - Use of controls, adjustments, or performance of procedures other than those specified in this
manual may result in hazardous radiation exposure.
EPA ENERGY STAR COMPUTERS AWARD
The Elite XL printer is designed to conserve electricity. With
its power-saving design, the Elite XL qualifies for the U.S.
Environmental Protection Energy Star Computers Award.