7
WALL MOUNT INSTALLATION
1. Plug the power supply cord into the
9V DC jack on the base and into an
AC outlet.
2. Place handset in the base to charge
for 12 hours. The CHARGE/IN USE
light comes on indicating that the
battery is charging.
If you don’t charge the battery
properly (for 12 hours) when you
first set up the phone, the battery’s
long-term performance will be
compromised.
3. Plug the short telephone line cord
into the PHONE LINE jack on the
back of the base and into a modular
jack.
4. Install the base plate by putting the
tabs into the slots on the bottom of
the unit and then slide the base plate
toward the back of the unit to snap
into place.
5. Slip the mounting holes over the
wall plate posts and slide the unit
down firmly into place. (Wall plate
not included.)
6. Set the TONE/PULSE switch to TONE
for touch-tone service, or PULSE for
rotary service. If you don’t know
which type of service you have,
check with the phone company.
7. Select RINGER ON or OFF (on the
side of handset). When you select
OFF, the handset doesn’t ring.
8. Raise the base antenna.
9. Set RING SELECT switch to 3 rings, 5
rings or TS (Toll Saver) according to
your requirement.
3
1
4
6
8
7
ON RINGER OFF
9