8
Installation
3. Insert the batteries.
4. Close the battery compartment by pushing the door
up until it snaps into place.
5. Plug the AC power adaptor of the charge cradle into
an electrical outlet.
6. Place the handsets in the charge cradles. The blue
CHARGE indicator turns on, verifying the batteries
are charging.
Allow handset to charge for 1 hours prior to rst
use. If you do not properly charge the handset,
battery performance is compromised.
CAUTION: To reduce the
risk of re or personal
injury, use only the
Thomson Inc. approved
model GP AAAHC 1.2V
0mAh, rechargeable
Nickel-metal Hydride
AAA batteries, which are
compatible with this unit.
Battery Performance
When batteries are fully
charged the handset displays
an icon of a full battery. To
keep your batteries in the best
condition, leave the handset
off the charge cradle for a
few hours at a time (after the
initial 16 hour charge).
Battery Low Warning
The handset displays a
ashing icon of an “empty”
battery and emits 3 warning
beeps. Recharge your handset
right away.
When charging the battery,
level bars are animated.
Battery Charging Light
The blue charging light on
the handset charge cradle
stays on while the handset is
on the cradle, even when the
batteries are fully charged.
Your unit is provided with three power adaptors; 2
for handset charger cradles and 1 base power. The
connectors are different sizes, only the larger power
adaptor is for the base unit.
Installing the Handset Battery
1. Locate batteries and battery door which are
packaged together inside a plastic bag and are
separate from the handsets.
2. Locate the battery compartment on the back of the
handsets.