GE DVMRe 16eZT, DVMRe 4eZT

0150-0198H 14 DVMRe Triplex eZ

RS232 Port 1

For a Modem connection or remote control of unit. See section 3.16 for information about configuring

the modem settings in the menu system. See section 9 for RS232 Remote Control Protocols.

DB-9 Pin Configuration For Port 1

Pin Use Pin Use Pin Use

1 DCD 4 DTR 7 RTS

2 RX 5 Ground 8 CTS

3 TX 6 Not Connected 9 Not Connected

DB-9 on back panel.

RS232 Port 2

For Event Generation and ASCII Text Insertion.

RJ-45 Pin Configuration For RS232 Port 2

Pin Use Pin Use

1 Ground 5 TXD

2 Reserved 6 Not Connected

3 Not Connected 7 Ground

4 RXD 8 Reserved

82 3 4 5 6 71

RJ-45 socket on

back panel.

1.8 Power-Up

Use the diagram below to secure the power cord to the back panel.

Slide approximately 6 inches of the power cord through the pre-installed

cable tie (approximately 1 inch after the ferrite core).

Tighten the cable tie until the cord is secure. Do not over tighten.

Loop the power cord end around and insert into the power receptacle on

the back panel.