2

Verify Connectivity (PING command)

If the radio LEDs indicate that the radio network is operating properly, you can use the PING command from the AP to verify the link integrity between the AP and an endpoint device connected to the Remote radio. The following illustration shows the typical arrangement for this test.

To conduct a PING test, an Ethernet-enabled device must be connected to the Remote, and it must have a compatible IP address. Remote radios do not have an IP address and cannot be verified directly using this method.

Serial Connections

To check a serial connection, refer to Local Serial Configuration Menu. This section contains details on establishing an IP-to-serial or serial-to-serial connection.

2-12 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489

Page 33
Image 33
GE GFK-2489 user manual Verify Connectivity Ping command, Serial Connections