3

9. To install the circuit board onto the back plate (Figure7),

insert the antennas into the antenna shrouds, then gently

slide the top of the circuit board under the two top latches,

and snap the circuit board in at the bottom latch to secure it

in place.

Figure 7. Circuit board and back plate
Wiring

To wire the receiver, do the following:

1. Remove power (if applied) from the control panel.Use 22-

gauge, or larger, stranded wire to connect the +12, GND,

and DATA terminals on the receiver (Figure8) to the power,

common, and data terminals on the control panel.

Figure 8. Receiver wiring connections and LEDs
DIP switch settings

The DIP switches (Figure7) on the circuit board are used to set

the receiver module number. Use Table2 to set the DIP switches

to the desired module number.

Power up

When you apply power to the control panel, the green (power)

LED on the receiver (Figure8) blinks for approximately 10

seconds. Table 3 describes the receiver status based on LED

conditions.The lower red LED at the bottom of the receiver

(Figure8) may emit a dim glow, but is not used as an indicator.

ON ECE
ON ECE
1 2 3 4
1 2 3 4

Circuit board

Wiring terminals

LEDs

DIP switches

Top latches

Bottom latch

Antenna shrouds

Back plate

+ 12 (to panel POS)

GND (to panel COM)

DATA (to panel DATA)

Green (power) LED

Red (data) LED

Red (not used) LED

Table 2. DIP switch settings
Module number 32 Module number 33
Module number 34 Module number 35 (default)
Module number 36 Module number 37
Module number 38 Module number 39
Table 3. LED indications
Green (power) LED status Meaning
Power-up blinks LED blinks represent Product Version Number
(PVN). Long blink on is 1, short blink on is 0. PVN
is in binary, from most significant to least signif-
icant bit.
Off No packets from sensors being received.
Short blink on Receiver received a valid packet from an
unknown sensor.
Long blink on Receiver received a valid packet from an
enrolled sensor.
Red (data) LED status Meaning
Off No data communication with the control panel.
Check wiring and power source.
Short blink on Normal data communication with the control
panel.
ON
12 43
EDG
ON
12 43
EDG
ON
12 43
EDG ON
1 2
4
3
EDG
ON
1 2
4
3
EDG ON
1 2
4
3
EDG
ON
1 2
4
3
EDG
ON
12 43
EDG