Grizzly H0594 instruction sheet

This 8,000 RPM air sander requires 90 PSI and

6 CFM. Air inlet is 1/4" NPT. Requires 31/2" x 81/2"

sanding sheets. (You can cut a standard 9" x 11"

sanding sheet into thirds and trim each piece to

size.)

A. Pneumatic Jitterbug Sander ....................... 1

MODEL H0594

Figure 2. Attaching sanding sheet.

Figure 1. Model H0594.

To assemble the sander and attach the sand-

paper:

1. Install a 1⁄4" NPT male quick-disconnect fitting

(not included) into the air inlet.

2. Press one clamp open, insert one end of the

sandpaper between the clamp and the base

as shown in Figure 2 and release pressure

on the clamp to secure the paper.

3. Fold the sandpaper over the sander, and

secure the paper in the opposite clamp, mak-

ing sure the paper fits snugly as shown in

Figure 3.

Figure 3. Attaching sandpaper on opposite side.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#BL8253 PRINTED IN TAIWAN

EYE INJURY HAZARD!

Always wear safety glasses

when using this tool to

prevent serious personal

injury.

INJURY HAZARD!

Always disconnect tool from

air to prevent unexpected

operation during service.

DUST HAZARD!

Always wear respirator when

using this tool.