15
INSTALLATION INSTRUCTIONS
Select a suitable location for the dryer on a hard even surface away from direct
sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc.
Any floor unevenness should be corrected with the leveling legs located on the
bottom of the dryer.
Phillips head and flathead screwdrivers
Channel-lock adjustable pliers
1/2 inch open end wrench
Spirit level
Measuring tape (12ft. Min.)
Duct tape
Rigid or flexible metal 4 inch (10.2 cm) duct
Vent hood
Power Supply:
3 wire, 220V Volt, 30 Amp, 50Hz, 1 Phase
Power Supply Cord Kit:(not supplied when sold)
The dryer MUST employ a 3-conductor power supply cord NEMA(245IEC66
450V/750V) rated at 220 Volt AC minimum, 30 Amp., with 3 open end
spade lug connectors with upturned ends or closed loop connectors and
marked for use with clothes dryers.
1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the dryer accessories inside and outside.
2. Inspect and remove any remains of packaging, tape or printed
materials before using the dryer.
Tools and Materials Required
Electrical Requirements
Unpacking Your Dryer