TROUBLE SHOOTING

PROBLEM

POSSIBLE FAULT

REMEDY

 

 

 

Motor fails to start.

Mains supply socket dead.

Test socket by plugging in anoth-

 

 

er appliance.

 

RCCB tripped.

Remove mower plug and check

 

 

RCCB action. Check the supply

 

 

cable for any obvious signs of

 

 

damage and replace immediately

 

 

if defective. If no obvious faults

 

 

are found a serious fault is indi-

 

 

cated. Contact your Hayter

 

 

Dealer.

 

Plug pulled out of mains

Re-engage plug.

 

socket.

 

 

Fuse failure.

Fit a new 13 amp fuse.

 

Supply cable damaged.

Disconnect from the mains and

 

 

check the supply cable for any ob-

 

 

vious signs of damage. Replace

 

 

immediately if defective.

 

Cutterblade obstructed.

Disconnect from the mains and

 

 

remove any obstructions.

Motor will not stop.

Faulty switch control unit.

Ensure switch lever has returned

 

 

to the 'OFF' position. Disconnect

 

 

from the mains and contact your

 

 

Hayter Dealer.

 

 

 

Cutterblade runs on exces-

Faulty brake unit.

Contact your Hayter Dealer.

sively after switching

 

 

'OFF'.

 

 

1.23