9

How To Set Timer

1 How to set days on which water

conditioner is to regenerate.

Rotate the skipper wheel until the number "1" is at the red
pointer. Set the days that regeneration is to occur by
sliding tabs on the skipper wheel outward to expose trip
fingers. Each tab is one day. Tab at red pointer is tonight.
Moving clockwise from the red pointer, extend or retract
fingers to obtain the desired regeneration schedule.
Make certain the tab aligned with red pointer is not
extended outward. The filter must not regenerate
within 24 hours of installation to allow the filter media
to absorb water and not be backwashed out.
2 How to set the time of day.
Press and hold the red button in to disengage the drive
gear.
Turn the large gear until the actual time of day is aligned
with the time of day pointer.
Release the red button to again engage the drive gear.
The Iron Curtain is preset to regenerate at 12:00 a.m.
provided the time of day is correct.
Service
Position
Indicator
24 Hr. Gear
Manual Regeneration Knob
TO SET TIME OF DAY -PRESS RED BUTTON AND TURN LARGE DIAL UNTIL TIME I S AT ARROWTO MANUALLY START CYCLE - TURN KNOB CLO CKWI SE
12-Day Skipper Wheel
(Shows every other
day regeneration)
Red Time
Set Button
Red
Pointer
FIGURE 4
FIGURE 2
AIR-OUT
AIR-IN
PRESSURE
TANK
TO OUTSIDE
HOSEBIBBS
PRESSURE
RELIEF VALVE
IRON
CURTAIN
AERATION
ASSEMBLY
IRON
CURTAIN
FILTER
DRAIN LINE
OPTIONAL
FILTER INLET
SHUT-OFF
THREE-VALVE
BY-PASS
CHECK
VALVE
INLET
SHUT-OFF
OUTLET
SHUT-OFF
FILTERED WATER
TO WATER
SOFTENER
FILTERED UNSOFTENED
WATER TO KITCHEN SINK
FIGURE 3
PRESSURE
TANK
TO OUTSIDE
HOSEBIBBS
PRESSURE
RELIEF VALVE
IRON
CURTAIN
AERATION
ASSEMBLY
IRON
CURTAIN
FILTER
DRAIN LINE
THREE-VALVE
BY-PASS
CHECK
VALVE
OUTLET
SHUT-OFF
FILTERED UNSOFTENED
WATER TO KITCHEN SINK
INLET
SHUT-OFF
AIR-OUT
FILTERED WATER
TO WATER
SOFTENER
OPTIONAL
FILTER INLET
SHUT-OFF
AIR-IN