USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS
USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS
Operating the
This Genius Remote is designed to operate different types of VCRs. You must first program the Genius Remote to match the remote system in your VCR. (Refer to Table 1 on page 31 or Table 3 on page 32.)
1.Set the
2.Set the USE/LEARN mode select switch on the rear side of the Genius Remote to "USE." (For CLU- 851GR only)
3.Turn ON your VCR.
4.Aim the Genius Remote control at the front of your VCR.
5.While holding down the SELECT button, press the button that matches your VCR as shown on page 31 or page 32. Continue to hold down both buttons. The channels of the VCR will begin changing when the correct button is pressed. When this occurs, the Genius Remote Control is programmed for your VCR. If the VCR channels do not change after 5 seconds, try a different Genius Remote button.
6.Release both buttons when the VCR starts to change channels. The Genius Remote will now control your VCR.
Click here to see the
NOTES:
1.If your VCR cannot be operated after performing the above procedures, this means that your VCR's codes have not been precoded into the GENIUS REMOTE. Please store your VCR codes in memory by using the USER mode. (Refer to page 33.)
2.The GENIUS REMOTE CONTROL will remember the codes you have programmed in until the batteries are removed from the GENIUS REMOTE CONTROL. After replacing the batteries repeat the entire programming procedure stated above.
3.If you have a play back only VCR (no CH UP/DOWN function), please follow operating step 5 described above and then check a VCR function until you find the button that will allow the precoded VCR buttons to operate your VCR.
QPRECODED VCR BUTTONS
These buttons always transmit the chosen precoded VCR codes.
RSELECT BUTTON
This is for setting up the Genius Remote to transmit the VCR's remote codes.
SEXCLUSIVE TV BUTTONS These buttons are for operating the TV.
37