USING THE GENIUS REMOTE TO LEARN ADDITIONAL
FUNCTIONS FOR
If the storing was not done correctly, or the codes are too long to learn, or no more codes can be stored in memory due to memory overflow, the LEARN indicator and READY indicator will flash ON and OFF.
VSet the LEARN/USE mode select switch on the back of the Genius Remote to "USE" and check that the button to which the code is stored operates correctly. If it does not operate correctly, repeat from step 1.
WRepeat steps 3 to 5 to store other keys.
To clear the stored codes from the USER mode
Set the
To remember stored codes, it is convenient to paste the labels (user's label) provided on the buttons for the USER page. If the correct labels are not provided, it is possible to write these letters on an empty label with a ballpoint pen.
Example of User's Labels
NOTE:
1.To operate your TV, be sure to point the Genius Remote at the remote sensor on the television. To operate other electronic equipment like a VCR, point the remote at the sensor on the device.
2.Refer to the instruction manual of the VCR for operation on the buttons exclusively for the VCR.
3.Be sure to keep the original remote transmitter even after storing its codes in the Genius Remote Control.
4.If the Genius Remote is left with its batteries removed, the learned codes in its memory are erased and will have to be reprogrammed into the memory.
5.The Genius Remote Control may not be able to learn certain special remote codes.
CAUTION ON BATTERIES:
1.The Genius Remote Control is working when the LEARN indicator lights up when a button is pressed.
2.When you press a button and the learn indicator will not light up or if the operation is extremely slow, this is an indication that the batteries should be replaced.
3.Even if the batteries seem dead, do not remove them until you have replacement batteries ready to put in. The codes stored in memory will be erased in a few minutes without power. When replacing batteries, prepare the new ones first.
45