FUNCTIONS (31GX31B ONLY)

￿ EXCLUSIVE BUTTONS

These buttons are for operating the TV.

Storing Operation

￿Set the remote transmitter as shown below.

Put the remote transmitter which contains the codes to be stored and the GENIUS REMOTE transmitter to face each other. (Distance should be 2 - 4 inches.)

￿Set the LEARN/USE mode select switch located on the back of the Genius Remote to the LEARN position.

￿Set the MULTI-PAGE select switch to "USER" position.

￿4. Press one of the learnable buttons on the Genius Remote, ("7" in this example). This button will be used to store the new code. The READY indicator will light at this time. (The light will remain lit for approximately 15 seconds. If no other function is performed at this time, the operation is canceled.)

The Genius Remote is ready to receive an infrared code from another remote.

5.Press and hold the button down on the other transmitter which contains the code to be stored, while the READY light is lit.

Release the button after both the READY indicator goes out and the LEARN indicator lights.

When storing has been performed correctly, the LEARN indicator lights for about 2 seconds.