USING THE GENIUS REMOTE TO CONTROL CABLE BOX FUNCTIONS

USING THE GENIUS REMOTE TO CONTROL CABLE BOX FUNCTIONS

Operating the pre-coded function for your Cable Box

This Genius Remote is designed to operate different types of cable boxes. You must first program the Genius Remote to match the remote system in your cable box. (Refer to Table 2 on page 36 or Table 4 on page 37.)

1.Set the MULTI-PAGE select switch to "CATV".

2.Set the USE/LEARN mode select switch to "USE." (For CLU-850GR only)

3.Turn ON your cable box.

4.Aim the Genius Remote control at the front of your cable box.

5.While holding down the SELECT button, press the button that matches our cable box as shown on page 36 or page 37. Continue to hold down both buttons. The channels of the cable box will begin changing when the correct button is pressed. When this occurs, the Genius Remote Control is programmed for your cable box. If the cable box channels do not change after 5 seconds, try a different Genius Remote button.

6.Release both buttons when the cable box starts to change channels. The Genius Remote will now control your cable

Click here to see the CLU-850GR in the CATV position.

NOTES:

1.If your cable box cannot be operated after performing the above procedures, this means that your cable box codes have not been precoded into the GENIUS REMOTE. Please store your cable box codes in memory by using the USER mode. (Refer to page 38.)

2.The GENIUS REMOTE CONTROL will remember the codes you have programmed in until the batteries are removed from the GENIUS REMOTE CONTROL. After replacing the batteries repeat the entire programming procedure stated above.

￿ PRECODED FOR CABLE BOX

These buttons always transmit the chosen precoded CATV codes.

￿ SELECT BUTTON

This is for setting up the cable box's Pre-code.

￿ EXCLUSIVE TV BUTTONS

These buttons are for operating the TV.

51