CONNECTING EXTERNAL VIDEO SOURCES
14
The exact arrangement you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTVSet Top Box to your Plasma
TV is dependent on the model and features of each component. Check the owner’s manual of each component for the location of
video and audio inputs and outputs.
The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your
particular assortment of components and features. For best performance, video and audio cables should be made from coaxial
shielded wire.
Before Operating External Video Source
The input mode is changed when the VID1~VID5 button is pressed as shown below. Connect an external source to the INPUT
terminal, then press the VID1~VID5 button as necessary to view the input source (see page 31).
INPUT MODE SELECTION ORDER
(ANTENNA) (INPUT)
VID1
ANT
3:32 PM
Ant A 32
Stereo
3:32 PM
YPBPR:1
VID1
Stereo
1080i Format
CONNECTING AMONAURAL AUDIO SOURCE TO INPUT2~INPUT5
1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack, as shown on the AVC
Center below.
2. Connect the cable from the AUDIO OUTof the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.
3. Press the VID2~VID5 button to view the program from the VCR or the laserdisc player. The VIDEO mode disappears
automatically after approximately four seconds.
4. Press the ANTbutton to return to the previous channel.
P
B
P
R
P
B
P
R
DVI-HDTV
INPUT 1
L
AUDIO
R
AUDIO OUT
ANALOG INPUT
L/(MONO)
R
AUDIO
RGB TruBass SRS and symbol are trademarks of SRS Labs, Inc.
Rear Panel of AVC Center
L/(MONO)
INPUT 3 IR BLASTER
AUDIO
VIDEO OUT
AUDIO OUT
VCR
Y/VIDEO
R
L/(MONO)
AUDIO
L
R
S-VIDEO
VIDEO
AUDIO
R
S-VIDEO
VIDEO
R
S-VIDEO
VIDEO
MONITOR OUT INPUT 4
L/(MONO)
AUDIO
Y
R
L/(MONO)
AUDIO
INPUT 2 INPUT 1
ANT B TO CONVERTER ANT A
AC IN
TO MONITOR
Please use HITACHI specified cable.
Back of VCR
FIRST TIME USE