English
DADO CUTS (FIG. BB)
1.The dado blade insert is included with this saw. Remove the saw blade, original table insert and blade guard. Install the dado and dado blade insert.
2.Instruction for operating the dado is packed with the separately purchased dado set.
3.The arbor (1) on this saw restricts the maximum width of the cut to 13/16”.
4.When making full 13/16” dado cuts, it is not necessary to install the outside fl ange (2) before screwing on the arbor nut (3). Make sure that the arbor nut (3) is tight, and that at least one thread of the arbor sticks out past the nut.
5.Do not exceed 8” diameter dadoes and keep the width 13/16” or less. It will be necessary to remove the blade guard and splitter when using a dado blade. Always use caution when operating a dado blade.
6.Use only the correct number of round outside blades and inside chippers as shown in the dado set’s instruction manual. Blade or chipper must not exceed 13/16”.
7.Check saw to ensure that the dado will not strike the housing, insert, or motor when in operation.
WARNING
For your own safety, always replace the blade, blade guard assembly, and blade insert when you are finished with the dado operation.
Fig. BB
2
3
22