English
PRECAUTIONS ON USING JIG SAW |
| 2. This Jig saw employs a | |
machine is used continuously at low speed, an extra | |||
|
| ||
1. Hold power tool by insulated gripping surfaces, when | load is applied to the motor which can result in motor | ||
performing an operation where the cutting accessory | seizure. Always operate the power tool so that the | ||
may contact hidden wiring or its own cord. Cutting | blade is not caught by the material during operation. | ||
accessory contacting a "live" wire may make exposed | Always adjust the blade speed to enable smooth | ||
metal parts of the power tool "live" and could give | cutting. | ||
the operator an electric shock.
SPECIFICATIONS
Voltage (by areas)* | (110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V) | |
Power Input* | 705 W | |
Max. Cutting Depth | Wood 90 mm | |
Mild Steel 8 mm | ||
| ||
850 – 3000 | ||
Stroke | 20 mm | |
Min. Cutting Radius | 25 mm | |
Weight (without cord) | 2.2 kg |
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES |
| |
(1) | Blades (No. 41) .......................................................... | 1 |
| Refer to Table 1 for use of the blades. |
|
(2) | Hexagon bar wrench ................................................. | 1 |
Standard accessories are subject to change without | ||
notice. |
| |
OPTIONAL ACCESSORIES ... Sold separately
(1)Various types of blades
Refer to Table 1 for use of the blades.
(2)Guide
(3)Sub base
(4)Bench stand (Model
(5)Splinter guard
(6)Dust collection adapter
Optional accessories are subject to change without notice.
APPLICATIONS
Cutting various lumber and pocket cutting
Cutting mild steel plate, aluminum plate, and copper plate
Cutting synthetic resins, such as phenol resin and vinyl chloride
Cutting thin and soft construction materials
Cutting stainless steel plate (with No. 97 blade)
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate.
2.Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the power switch is in the ON position, the power tool will start operating immediately, which could cause a serious accident.
3.Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable.
4.Dust produced in operation
The dust produced in normal operation may affect the operator’s health. Either of following way is recommended.
a)Wear a dust mask
b)Use external dust collection equipment
When using the external dust collection equipment, connect the adapter with the hose from external dust collection equipment.
5. Changing blades
(1)Open the lever up to the stop. (Fig.
(2)Remove fitted blade.
(3)Insert new blade up to the stop in the blade holder. (Fig.
(4)Close the lever. (Fig.
CAUTION:
Be sure to switch power OFF and disconnect the plug from the receptacle when changing blades.
Do not open the lever when plunger is moving.
NOTE:
Confirm the protrusions of blade inserted to the blade holder surely. (Fig. 2)
Confirm the blade located between the groove of
roller. (Fig. 3)
6.Adjusting the blade operating speed
This Jig Saw is equipped with the electric control circuit which enables stepless speed control. To adjust the speed, turn the dial shown in Fig. 4. When the dial is set to “1”, the jig saw operates at the minimum speed
7