22

1

Power

Button

Device

Buttons

Numeric

Buttons

2

3

How To Use The Remote Control To Control Your AV Device
NOTES If your AV device cannot be operated after performing the above procedures, your AV device code has not been •
preprogrammed into the remote control.
In the unlikely event that your AV device cannot be operated after performing the above procedures, please consult your •
AV device owners guide.
The remote control• will remember the codes you have programmed even after the batteries are removed from the remote
control. To reset all programmed codes to factory default place remote control in TV mode, then press and hold TV mode
button and enter “9”, “8”, “1” in sequence.
OPERATING THE PRECODED FUNCTIONS FOR YOUR AV DEVICE.
The new remote control is designed to operate different types of VCRs, cable boxes, set top boxes, satellite receivers, DVD players, and
other audio/video device. You must rst program the remote control to match the remote control system of your AV device (refer to pages
26~27 for a preprogrammed code number).
AV DEVICE CONTROL SETUP PROCEDURE
Turn on your AV device.1.
Select the desired mode: DVD, PVR/VCR, SAT/CBL or AVR 2.
by pressing the corresponding button.
Hold down the device button (DVD, PVR/VCR, SAT/CBL or 3.
AVR) on the remote control and enter the four digit preset
code that matches your device as shown on pages 26~27.
Release the device button.4.
If done correctly, the device LED indicator will blink 3 times 5.
to conrm proper setup.
The remote control will now control the desired device.6.
SETUP EXAMPLE (Hitachi Cable Box with precode 0003)
Turn ON your Cable box.1.
Select cable mode by using your SAT/CBL button to position 2.
the LED indicator on SAT/CBL.
Hold down the SAT/CBL button on the remote control and 3.
press the numbers 0, 0, 0 and 3.
Release the SAT/CBL button.4.
The indicator light will ash 3 times if the code was accepted.5.
Aim the remote control at the cable box and press the 6.
POWER button. The remote control will turn off your cable
box when the correct four digit preset code is entered. When
this occurs, the remote control is programmed for your cable
box. If the cable box does not turn off, try a different four digit
preset code.
The remote control will now control your cable box.7.
Repeat the same procedure for your set top box or satellite
receiver (select SAT/CBL), your DVD (select DVD), your VCR/
PVR(select VCR/PVR), or your AVR (select AVR).